RoomGuard Installation

Follow this simple guide to install the RoomGuard logging device and start collecting data

Installation steps

1

Unbox the RoomGuard device.

2

Mount the room probe on the wall at the height you want to measure the room temperature, humidity and pressure.Make sure that it is not installed close to a heat source or in direct line of an aircondition exhaust.

3

Plug the connector from the room probe in the middle connector on the RoomGuard device named Room Probe

4

Connect the external power supply to the RoomGuard device

5

Connect the external power supply to a wall socket.
The RoomGuard device is now turned on an will automatically connect to the Internet and start sending data.

6

Go to the Synap Portal to continue the installation.

7

In the Portal identify the installed device and click on it and go to the Settings tab.

8

Rename the device so it is easy indentifiable and add a location and a description for the device. Finish by clicking the Save button.

9

Select the Timing interval and enter the threshold values for the device. Finish by clicking the Save button.

10

Add the users that should be notified in case the threshold values are reached.